This forum is in archive mode. You will not be able to post new content.

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - JackBruno

Pages: [1]
1
lspci -knn
Code: [Select]
00:00.0 Host bridge [0600]: Intel Corporation Atom Processor D4xx/D5xx/N4xx/N5xx DMI Bridge [8086:a010]
Subsystem: Samsung Electronics Co Ltd Notebook N150P [144d:c072]
Kernel driver in use: agpgart-intel
00:02.0 VGA compatible controller [0300]: Intel Corporation Atom Processor D4xx/D5xx/N4xx/N5xx Integrated Graphics Controller [8086:a011]
Subsystem: Samsung Electronics Co Ltd Notebook N150P [144d:c072]
Kernel driver in use: i915
Kernel modules: i915
00:02.1 Display controller [0380]: Intel Corporation Atom Processor D4xx/D5xx/N4xx/N5xx Integrated Graphics Controller [8086:a012]
Subsystem: Samsung Electronics Co Ltd Notebook N150P [144d:c072]
00:1b.0 Audio device [0403]: Intel Corporation NM10/ICH7 Family High Definition Audio Controller [8086:27d8] (rev 02)
Subsystem: Samsung Electronics Co Ltd Notebook N150P [144d:c072]
Kernel driver in use: snd_hda_intel
Kernel modules: snd-hda-intel
00:1c.0 PCI bridge [0604]: Intel Corporation NM10/ICH7 Family PCI Express Port 1 [8086:27d0] (rev 02)
Kernel driver in use: pcieport
Kernel modules: shpchp
00:1c.1 PCI bridge [0604]: Intel Corporation NM10/ICH7 Family PCI Express Port 2 [8086:27d2] (rev 02)
Kernel driver in use: pcieport
Kernel modules: shpchp
00:1c.2 PCI bridge [0604]: Intel Corporation NM10/ICH7 Family PCI Express Port 3 [8086:27d4] (rev 02)
Kernel driver in use: pcieport
Kernel modules: shpchp
00:1c.3 PCI bridge [0604]: Intel Corporation NM10/ICH7 Family PCI Express Port 4 [8086:27d6] (rev 02)
Kernel driver in use: pcieport
Kernel modules: shpchp
00:1d.0 USB controller [0c03]: Intel Corporation NM10/ICH7 Family USB UHCI Controller #1 [8086:27c8] (rev 02)
Subsystem: Samsung Electronics Co Ltd Notebook N150P [144d:c072]
Kernel driver in use: uhci_hcd
00:1d.1 USB controller [0c03]: Intel Corporation NM10/ICH7 Family USB UHCI Controller #2 [8086:27c9] (rev 02)
Subsystem: Samsung Electronics Co Ltd Notebook N150P [144d:c072]
Kernel driver in use: uhci_hcd
00:1d.2 USB controller [0c03]: Intel Corporation NM10/ICH7 Family USB UHCI Controller #3 [8086:27ca] (rev 02)
Subsystem: Samsung Electronics Co Ltd Notebook N150P [144d:c072]
Kernel driver in use: uhci_hcd
00:1d.3 USB controller [0c03]: Intel Corporation NM10/ICH7 Family USB UHCI Controller #4 [8086:27cb] (rev 02)
Subsystem: Samsung Electronics Co Ltd Notebook N150P [144d:c072]
Kernel driver in use: uhci_hcd
00:1d.7 USB controller [0c03]: Intel Corporation NM10/ICH7 Family USB2 EHCI Controller [8086:27cc] (rev 02)
Subsystem: Samsung Electronics Co Ltd Notebook N150P [144d:c072]
Kernel driver in use: ehci-pci
00:1e.0 PCI bridge [0604]: Intel Corporation 82801 Mobile PCI Bridge [8086:2448] (rev e2)
00:1f.0 ISA bridge [0601]: Intel Corporation NM10 Family LPC Controller [8086:27bc] (rev 02)
Subsystem: Samsung Electronics Co Ltd Notebook N150P [144d:c072]
Kernel driver in use: lpc_ich
Kernel modules: lpc_ich
00:1f.2 SATA controller [0106]: Intel Corporation NM10/ICH7 Family SATA Controller [AHCI mode] [8086:27c1] (rev 02)
Subsystem: Samsung Electronics Co Ltd Notebook N150P [144d:c072]
Kernel driver in use: ahci
Kernel modules: ahci
00:1f.3 SMBus [0c05]: Intel Corporation NM10/ICH7 Family SMBus Controller [8086:27da] (rev 02)
Subsystem: Samsung Electronics Co Ltd Notebook N150P [144d:c072]
Kernel modules: i2c-i801
05:00.0 Network controller [0280]: Broadcom Corporation BCM4313 802.11bgn Wireless Network Adapter [14e4:4727] (rev 01)
Subsystem: Wistron NeWeb Corp. Device [185f:051a]
Kernel driver in use: wl
Kernel modules: wl, bcma
09:00.0 Ethernet controller [0200]: Marvell Technology Group Ltd. 88E8040 PCI-E Fast Ethernet Controller [11ab:4354]
Subsystem: Samsung Electronics Co Ltd Notebook N150P [144d:c072]
Kernel driver in use: sky2
Kernel modules: sky2

....

EDIT: just leave your reply be back tomorrow!

Staff note: please do not double post.. use the modify button instead

2
Yes it cause an error i tried this before...
Code: [Select]
Error for wireless request "Set Mode" (8B06) :
    SET failed on device eth1 ; Operation not supported.

3
hola amigos! my problem still annoying me!
Code: [Select]
Interface    Chipset        Driver

eth1        Broadcom    wl - [phy0]mon0: ERROR while getting interface flags: No such device

                (monitor mode enabled on mon0)

WHAT I DID!
*apt-get install b43-fwcutter firmware-b43-installer (DID NOTHING!)
*modprobe -r b44 b43 b43legacy and modprobe wl (DID NOTHING!)
*reinstall aircrack (SAME!)

now if theres a command! i need to type like lspci, etc... etc... just reply it
thanks in advance!

4
Hacking and Security / Re: Airmon-ng goes weird!
« on: September 02, 2014, 01:57:18 PM »
Code: [Select]
airmon-ng check kill
...
...
...
killing all those process
...
Code: [Select]
dmesg | grep eth1
....
[same as above]

5
Hacking and Security / Re: Airmon-ng goes weird!
« on: September 02, 2014, 01:03:56 PM »
Okay i run ...
Code: [Select]
dmesg | grep eth1

[   19.894588] eth1: Broadcom BCM4727 802.11 Hybrid Wireless Controller 6.20.155.1 (r326264)
[  233.870793] ERROR @wl_notify_scan_status : eth1 Scan_results error (-22)
i tried to remove my interface from wicd and run it... same!

6
Hacking and Security / Re: Airmon-ng goes weird!
« on: September 02, 2014, 12:51:48 PM »
okay... i already did this but. here it is
Code: [Select]
airmon-ng check eth1

PID Name
1019 avahi-daemon
1020 avahi-daemon
3464 wpa_supplicant
3487 dhclient
Process with PID 3464 (wpa_supplicant) is running on interface eth1
Process with PID 3487 (dhclient) is running on interface eth1
and what do you mean about dmesg command? do i need to copy that crap and paste it here? thats kinda
longer

7
Hacking and Security / Re: Airmon-ng goes weird!
« on: September 02, 2014, 12:00:16 PM »
lol.. that is the first thing that i do! when i got this error...

8
Hacking and Security / Re: Airmon-ng goes weird!
« on: September 02, 2014, 11:36:26 AM »
Okay as you wish.
Code: [Select]
ifconfig -a
eth0      Link encap:Ethernet  HWaddr e8:11:32:2e:a6:fd 
          UP BROADCAST MULTICAST  MTU:1500  Metric:1
          RX packets:0 errors:0 dropped:0 overruns:0 frame:0
          TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:1000
          RX bytes:0 (0.0 B)  TX bytes:0 (0.0 B)
          Interrupt:18

eth1      Link encap:Ethernet  HWaddr 00:1b:b1:a9:ac:e0 
          inet addr:192.168.1.124  Bcast:192.168.1.255  Mask:255.255.255.0
          inet6 addr: fe80::21b:b1ff:fea9:ace0/64 Scope:Link
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:25357 errors:8 dropped:0 overruns:0 frame:34474
          TX packets:29140 errors:34 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:1000
          RX bytes:17317109 (17.3 MB)  TX bytes:4038775 (4.0 MB)
          Interrupt:16

lo        Link encap:Local Loopback 
          inet addr:127.0.0.1  Mask:255.0.0.0
          inet6 addr: ::1/128 Scope:Host
          UP LOOPBACK RUNNING  MTU:65536  Metric:1
          RX packets:43 errors:0 dropped:0 overruns:0 frame:0
          TX packets:43 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:0
          RX bytes:7460 (7.4 KB)  TX bytes:7460 (7.4 KB)
and then...
Code: [Select]
lo        no wireless extensions.

eth0      no wireless extensions.

eth1      IEEE 802.11abg  ESSID:"KISSHEART" 
          Mode:Managed  Frequency:2.437 GHz  Access Point: C0:C1:C0:2B:E4:89   
          Bit Rate=5.5 Mb/s   Tx-Power=200 dBm   
          Retry  long limit:7   RTS thr:off   Fragment thr:off
          Encryption key:off
          Power Management:on
          Link Quality=26/70  Signal level=-84 dBm 
          Rx invalid nwid:0  Rx invalid crypt:0  Rx invalid frag:0
          Tx excessive retries:0  Invalid misc:0   Missed beacon:0

9
Hacking and Security / Re: Airmon-ng goes weird!
« on: September 02, 2014, 11:27:37 AM »
yeah... i always logged in as root... and thanks for fast reply!

10
Hacking and Security / Airmon-ng goes weird!
« on: September 02, 2014, 11:11:15 AM »
hey all of you awesome hackers. i just need your help for a bit. i installed airmon-ng package suit... for security reasons e.g exploiting own routers to detect some bugs. but. airmon-ng start to act weird...
Code: [Select]
Interface    Chipset        Driver

eth1        Broadcom    wl - [phy0]mon0: ERROR while getting interface flags: No such device

                (monitor mode enabled on mon0)
weird right? but i tried to reinstall the bcmw-kernel-source... and reinstall aircrack-ng package
nothing happens!

i hacked a lot of wifi using different techniques. but now i can't turn my wireless adapter into monitor mode. my perl programs are useless!

Pages: [1]


Want to be here? Contact Ande, Factionwars or Kulverstukas on the forum or at IRC.